Vertical Shot Blasting Machine
The shot blasting machine adopts this way to get projectiles by mechanical material (Shot or sand) to a very high speed and a certain angle to the work surface, so that the impact produced by projectile materials can clear the workpieces’s surface and then inside the machine the projectile material and impurities will be recovered respectively through the vacuum cleaner air and can be reused again.
ADD to Quote
Equipment use

HCV500 is mainly used for large surface cleaning which is not easy to move, such as wind tower, oil tank, hull external surface, various steel pipe outer wall with diameter of over 300mm.

Working process

This machine is a vertical hanging wall type blasting cleaning machine.The specific working process is as follows:

Remote boot → dust collector  Suspension hoisting mechanism lift main machine to clean up the initial position  Start mobile shot blast cleaning system, setting speed  Clear clean up and down slowly moving shot blast cleaning system (shot blasting system with a full range of the projectile circulation machine dust removal system) the equipment clean up 500 mm wide, clean up to the lower part of the artifact, across organizations to drive mobile transverse blast cleaning system is 500 mm, transverse traction organization at the same time, 500 mm (in the drawing,during the lifting and rolling process, the magnetic adsorption mechanism will attach the moving cleaning mechanism to the side wall of the workpiece in accordance with the pr-adjusted magnetic force.  The suspension hoist will lift the moving shot throwing mechanism again to the new initial position of cleaning (the equipment needs to work from top to bottom to start the next cycle)

Technique parameters

Technique parameters

1.1Capacity:~50m2/h;Cleaning efficiency of epoxy seven is about 25-60 m2/h, to cleaning rust 40-70 m2/h

1.2Cleaning width:500mm; 

1.3Blasting wheel power:11kw;

1.4Abrasive:≤S550 steel shot;

Related Suggestion

Online Consultation